Filter
Sort by:
Show:

Target Pulley Lift Upgrade

The pulley lift system is an upgrade for existing NC100 and NC200 target lifts. This new lift is an improvement over the previous threaded rod lift in several ways: Quieter:...
$235.00

Clip for Athena EST Lead Collection Bags

This clip eliminates the need for rubber bands to secure lead collection bags to the collection funnel. Easily slide the clip on and off the target to secure or remove...
$9.00

Athena SD Card Downloadable File

Using your own microSD card and a simple 3rd party utility to write the Athena image file to the microSD card, you can quickly have your device up and running. ...
$20.00

Replacement SD Card

Our replacement SD can be used for any device in both our Athena at Home and Athena for Clubs systems, including NC100 and NC200 firing points, DoW100 athlete monitors, and...
$13.00

Camera Arm Replacement for NC100

The NC100 replacement camera arm can be easily swapped out for a damaged or broken one. It comes with all necessary components pre-installed, including the camera, power cable, and ribbon...
$135.00

Target Paper Roll Motor Assembly

This motorized assembly drives the feeding of the black target paper roll after every shot. Replacement is easy via the removal of only 2 bolts and a small power connector....
$125.00

Micro USB Power Supply

The Micro USB power supply with switch is a replacement for use with our DoW100 Athlete Monitors and MM100 Spectator Display modules. You must inspect your device to determine whether...
$15.00

Micro USB Power Switch

The Micro USB power switch is a replacement for use with our DoW100 Athlete Monitors and MM100 Spectator Display modules where the existing power supply does not have a built-in...
$5.00

USB Type-C Power Supply

The USB Type-C power supply with switch is a replacement for use with our DoW100 Athlete Monitors and MM100 Spectator Display modules. You must inspect your device to determine whether...
$15.00

USB Type-C Power Switch

The USB Type-C power supply is a replacement for use with our DoW100 Athlete Monitors and MM100 Spectator Display modules where the existing power supply does not have a built-in...
$5.00

Power Brick Holder for NC Models

The power brick holder serves a dual purpose in serving to hold the power supply for the NC model firing points and also as the lower mount that secures the...
$30.00

Power Protection Plate for NC Models

This steel protection plate is intended to protect your firing point’s power adapter from damage from accidental shots. It easily installs in the power adapter holder and secures in place...
$30.00
Show: